Filter
Top Products
8-48
www.topconpa.com
X20 Sprayer Reference Manual
As the wheel sensor passes past the magnet a pulse is
counted for every pulse from the radar.
5. Stop after approximately 20 meters (60 feet)
6. Put another mark on the ground alongside the same wheel
as used in Step 2
7. Measure the distance of the two marks, using a tape
measure
8. Press the calculator icon next to ‘Enter Distance’, in the
Calibrate window
The Wheel Factor is automatically calculated
9. Press ENTER to save the Wheel Factor and close the
window.
Distance Check
To check the Wheel Factor:
Press 1. Reset, in the Distance Check window (Figure 8-17
on page 8-47)
Drive back between the two marks made in steps 2 and 6 2.
during the Calibration
The distance travelled must be the same as the distance
measured, if it is not you must re-calibrate the Wheel
Factor.
Press 3. ENTER to save changes and return to the Setup page
(Figure 8-16 on page 8-46).