17-3
A2677 Rev 1.5
X20 Sprayer Reference Manual
Sprayer Software Settings
When setting up the software make sure the Close Valve When Flow
Off option (page 8-20) is not selected.
The controller mode must be selected as Standard (page 8-16) when
this kit is tted.
Setting the Pressure Relief
To adjust the Pressure Relief Valve you must know the correct working
pressures applicable to the spray nozzles. The valve needs to be set at a
point that will allow 1 Bar (approximately 100kpa) more than the
nozzle maximum pressure.
Place water into the Sprayer 1.
Start the pump 2.
Place the controller into manual and press the 3. Up arrow (▲) on
the screen for 20 seconds
Figure 17-2. Close Valve When Flow Off