Filter
Top Products
17-2
www.topconpa.com
X20 Sprayer Reference Manual
The Pressure Relief Valve will be tted between the pump in the
pressure hose and the Fast Valve.
The Pressure Hose is a 1 ¼" hose; it will need to be cut to add the
Pressure Relief Hose.
A Skin Fitting (supplied) must be tted to the tank, for the relief
chemical. Fit the Skin Fitting approximately 20 centimetres above
the base of the tank, so that "frothing" does not occur and agitation
is not enhanced.
The dealer/end users will have to supply an appropriate 1 ¼" chemi-
cal resistant hose, to connect the Pressure Relief Outlet and the Skin
Fitting. An appropriate hose clamp will also have to be supplied.
Once the pressure relief valve is tted to the pump. Pressure Outlet
Hose and then connected to the tank skin tting, wind the Pressure
Regulating Adjuster fully out, this will result in all uids being
"dumped".
Figure 17-1. Pressure Relief Valve Layout
From Pump
To Fast
Valve
Pressure
Relief Outlet
Skin fitting
to be fitted
to tank