Filter
Top Products
5-3
A2677 Rev 1.5
X20 Sprayer Reference Manual
Connect the 2. Power Comms harness to the Spray ECU and route
the red and black wires to a 12 Volt battery
Plug the 3. Switched Power connector that is located on the Power
Comms Harness, into the Switched Power connector on the X20
Power Cable
This connection ensures that the Spray ECU is only powered up
when the X20 console is switched ON.
Connect the end of the Power Comms Harness, that has a 4. DB
9-Pin to the next available COM Port on the back of the X20
console
Connect the other end of the Power Comms Harness to the 5.
16-Pin connector marked POWER/COMMS on the Spray ECU
WARNING
Do not connect the Power Comms harness to the
battery until the installation is complete.
WARNING
NOTICE
Use the cable ties provided to secure the Power
Comms Harness away from hot and moving parts,
and to avoid chaffing and wear.
NOTICE
TIP
If this connection is already being used, connect it
via the A1953 Power Splitter Harness.
TIP