Topcon A2677 Paint Sprayer User Manual


 
5-23
A2677 Rev 1.5
X20 Sprayer Reference Manual
WARNING
If the Valve Harness needs the connectors
replaced to suit the valve connectors, then
you should ensure that the Sprayer Harness is
disconnected from the Tractor Harness. Otherwise
damage to the Spray ECU will occur, if the wires
are shorted out during this procedure.
WARNING
Connecting to the Dump Valve
The Dump Valve (not supplied in kit) is activated when all
sections are switched OFF or when the Master Switch is switched
OFF, this directs all the flow back to the tank.
Connect the ARAG connector labeled 1. Dump 1 to the Dump
Valve
If the Dump Valve connector is on the Sprayer Harness,
then an adaptor will be required to connect the 4-Pin
Weather Pack to the Dump Valve. You must connect the
correct adaptor to the Dump Valve. See Table 5-1 on page
5-24 to determine which adaptor you should use.
NOTICE
The Dump Valve must be located between the pump
and Flow Meter.
NOTICE
TIP
If you notice that the Dump Valve is going in the
wrong direction, you have to swap the wires in the
Arag connector.
TIP