Filter
Top Products
5-15
A2677 Rev 1.5
X20 Sprayer Reference Manual
Installing the Shaft/Speed Sensor Kit to a
Tailshaft
On a tray mounted Sprayer the Shaft/Speed Sensor kit can be
used to read from the vehicle Tailshaft (Figure 5-8).
Securely 1. mount the Magnet Block on the flange, between the
Transmission Housing and Tailshaft, using the Hoseclamp or
other suitable means (Figure 5-8)
Please note: The wheel stud magnets are not used in this
case.
Securely mount the Shaft/Speed Sensor so it squarely faces 2.
the Magnet Block with a clearance of 2 to 3mm (1/16 to 1/8
inch), using an existing bolt on the transmission housing and
the supplied Mounting Brackets or other suitable means.
NOTICE
Do not attach the Magnet Block (Figure 5-8) directly to the
Tailshaft as its position changes, throughout its rotation.
NOTICE
Figure 5-8. Shaft/Speed Sensor installation to a Tailshaft