Filter
Top Products
8-14
www.topconpa.com
X20 Sprayer Reference Manual
Tank 1 Mode
Tank 1 Mode selects the appropriate units depending on which
mode is chosen, ie: when Liquid is selected then the units are set
to ‘Litres’, ‘L/Ha’ and Flow Sensor to ‘pulses per litre’ (if metric
units is selected, see page 8-55). For imperial units, the units could
be replaced with 'Gallons', 'Gallons/Acre' and Flow Sensor to
'Pulses per Gallon'
Tank Mode is normally set to Liquid for spraying.
Select Granular if using the Spray Rate Controller as a spreader
controller.
Select Injection if the Spray system has a Chemical Injection
Pump and a 2 or 4 channel MDECU installed.
Select NH3 if connecting the Spray Rate Controller to an
Anhydrous Gas Tank.
If Tank 2 or Tank 3 was selected in the Tanks window (page 8-13)
select the Tank Mode for each of these tanks in the appropriate
windows.
Controller 1
If Spray Interface is selected as the controller, then only Reg.
Valve (Regulator Valve) can be selected and that is why the option
is greyed out and no selection is possible.
If Spray ECU is selected as the controller, then either Reg. Valve
or Prop. Valve (Proportional Valve) can be selected. Depending
on whether the type of controller is Regulator or Proportional.
Select the Settings button (Figure 8-4 on page 8-13) to personalize
the Controller settings. See “Regulator Valve Settings”, page 8-16
if Reg. Valve is selected or “Proportional Valve Settings”, page
8-21 if Prop. Valve is selected.