Filter
Top Products
7-6
www.topconpa.com
X20 Sprayer Reference Manual
Setup
Once a Sprayer or Sprayer kit is selected then most of the Sprayer
values and settings will be loaded into the Sprayer software Options
and you will only have to enter a few values (eg. Section Widths, Unit
type, Wheel Calibration Factor) to get started.
You must choose one of two options:
Go to "Setting Up the Software", Chapter 8 of the Software •
Setup and work through the manual, which outlines all the
Sprayer options within the software
OR
Use the Quick Setup Guide (below) and enter in the Sprayer •
settings which are unique to your Sprayer.
Quick Setup Guide
Select the 1. Change/View Configuration button
This will allow you to view the settings of the Sprayer that was
loaded.
For help with understanding and navigating the Options
windows see Appendix A.
Select the COM Port the Spray ECU is connected to on the 2.
back of the console, on the ECU page, see page 8-6
Enter the Tank Capacity of the Sprayer, on the 3. Tanks page, see
page 8-13
Change the number of sections if they are different to the ones 4.
displayed on the Sections page, see page 8-26