Filter
Top Products
5-18
www.topconpa.com
X20 Sprayer Reference Manual
Most Flow Meters have a label on the meter body that shows the
Flow Meter Calibration Factor in pulses/volume. Eg: ‘645 ppl
(pulses per liter)’ or ‘2441 ppg (pulses per gallon)’. This means
the Flow Meter sends 645 pulses to the Spray ECU for every liter
(or 2441 pulses for every gallon) of liquid that passes through
the Flow Meter. This value is the Calibration Factor and will
be required to be entered into the Sprayer software setup (see
“Calibration Factor”, page 8-39).
Connecting to the Regulator Valve
The Regulator Valve (not supplied) is a motorized flow control
valve used to maintain the product flow to the section valves. It
will be situated between the pump and the Flow Meter.
Connect the Regulator Valve’s 2-Pin connector to the 2-Pin 1.
connector marked REG Valve 1 on the Sprayer Harness
(Figure 5-5 on page 5-10), using the Regulator Valve Adaptor
Harness (A802) (Figure 5-5 on page 5-10)
NOTICE
If connecting to a Raven Flow Meter. The value marked
on the label represents pulses/10 units of liquid. Divide
this number by 10 for the correct value to enter as the
Calibration Factor into the Sprayer software setup.
NOTICE
NOTICE
All bypass or agitation return lines that return to the tank,
must be taken before the Regulating Valve, so there is
no return path after the Regulating Valve and the Flow
Sensor.
NOTICE