Filter
Top Products
5-11
A2677 Rev 1.5
X20 Sprayer Reference Manual
Connecting to a Speed Sensor
This installation is used if connecting an A238 Shaft/Speed Sensor
kit (for ground speed) or A449 Radar Sensor Interface Harness
(not supplied in kit) to the Ground Speed Connector on either the
Tractor Harness or Sprayer Harness.
Select one of the following:
Installing the Shaft/Speed Sensor kit to an un-driven wheel on •
either the Tractor Harness or Sprayer Harness
Installing the Shaft/Speed Sensor kit to the Tailshaft of a •
vehicle on either the Tractor Harness or the Sprayer Harness
Use an existing Radar Speed sensor for Ground Speed•
Installing the Shaft/Speed Sensor Kit to an
Un-Driven Wheel for Ground Speed
The Shaft/Speed Sensor and Wheel Stud Magnets can be fitted to
any un-driven ground wheel, eg: the front wheel of the tractor or
wheel on a trailing Sprayer.
The magnet activates the sensor as the wheel magnets sweep past
(Figure 5-6 on page 5-12).
NOTICE
Connect to only one of the Ground Speed
connectors.
NOTICE
NOTICE
Use of a driven wheel for ground speed may be
subject to “wheel slip” and may not always reflect
true ground speed.
NOTICE