Filter
Top Products
4-3
A2677 Rev 1.5
X20 Sprayer Reference Manual
When no voltage is found, disconnect the vehicle’s battery 4.
before continuing with installation.
Testing Procedure for Installations With Existing
Switchbox (including Joystick Control):
Determine whether it is possible to disconnect the existing 1.
Switchbox without limiting existing functionality, eg: Boom,
Lift, Lower or Fold
If it is possible to disconnect the existing Switchbox without 2.
limiting existing functionality disconnect the Switchbox
On existing tractor harness, turn the ignition on 3.
Check each Section Drive Output pin for voltage 4.
(refer to manufacturer manual of existing tractor
harness for pin details)
When no voltage is found, disconnect the vehicle’s 5.
battery before continuing with installation.
WARNING
If it is not possible to remove the existing
Switchbox, without limiting functionality and
voltage is present, then you must install a Section
Drive Output Protection Adaptor (A2812 for 37-pin
on Connector 1 and A2813 for 16-pin on Connector
WARNING