Filter
Top Products
5-12
www.topconpa.com
X20 Sprayer Reference Manual
1. Glue the magnets to the wheel studs (Figure 5-6), with the
side marked with a plus (+) facing the Shaft/Speed Sensor.
TIP
Use any silicone or epoxy type adhesive to glue the
magnets to the wheel studs. Make sure you leave
adequate time for the glue to set.
TIP
NOTICE
Space the magnets equally around the wheel, on
all the available wheel studs (Figure 5-6), to ensure
accurate speed updates.
NOTICE
Figure 5-6. Shaft/Speed Sensor on an Un-Driven Wheel Installation
NOTICE
A wheel Calibration Factor of no greater than 0.6m
(24 inches) is required. See Section
NOTICE