Filter
Top Products
5-13
A2677 Rev 1.5
X20 Sprayer Reference Manual
Mount the Shaft/Speed Sensor to an existing structure on the 2.
wheel axle, ideally in a protected position to face the magnet.
To mount the Shaft/Speed sensor you can either:
Use the Mounting Bracket Assemblies (slotted brackets •
and angle brackets with hose clamps) provided (Figure
5-7 on page 5-14)
Fabricate your own mounting bracket to suit the •
Sprayer chassis.
NOTICE
There must be no movement of the sensor relative to
the magnet.
NOTICE
NOTICE
The distance between the Shaft/Speed Sensor to
Wheel Stud Magnet needs to be 2 to 3 mm (1/16 to
1/8 inch). The Shaft/Speed Sensor must be mounted
so that the Wheel Stud Magnets pass the sensor
evenly and squarely.
NOTICE