Filter
Top Products
4-2
www.topconpa.com
X20 Sprayer Reference Manual
Testing Procedure
You must complete one of two testing procedures, before upgrading
your software.
Make sure you choose the testing procedure that is applicable to your
product.
Testing Procedure For Installations With No
Existing Switchbox (switches on existing
controller)
On existing tractor harness, turn the ignition on 1.
Check each Section Drive Output pin for voltage (refer to 2.
manufacturer manual of existing tractor harness for pin
details)
Locate where voltage is supplied, to determine if it can be 3.
removed without limiting existing functionality
WARNING
Before commencing testing procedure
disconnect the existing tractor harness from the
existing controller.
WARNING
WARNING
If it is not possible to remove this voltage, then
you must install a Section Drive Output Protection
Adaptor (A2812 for 37-pin on Connector 1 and
A2813 for 16-pin on Connector 3).
WARNING