TROUBLESHOOTING & REPAIR
F-86 F-86
COMMANDER 400
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
SHUTDOWN SOLENOID REMOVAL AND REPLACEMENT (continued)
FIGURE F.35 – SHUTDOWN SOLENOID LEAD CONNECTIONS
PULL-IN COIL
(LARGER TERMINALS
EACH SIDE
#225 AND #262)
HOLD-IN COIL
(SMALLER TERMINALS
EACH SIDE
#224 AND #240)
IDLER
SOLENOID
SHUTDOWN
SOLENOID
PROCEDURE
1. Turn the engine off.
2. Unlatch, lift and secure the right side engine
access door.
3. Locate and remove the four spade connectors
that attach the shutdown solenoid terminals to
the wiring harness leads (#224, #240, #225
and #262). See Figure F.35. Cut the cable tie.