Lincoln Electric SVM133-B Welder User Manual


 
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
F-16 F-16
COMMANDER 400
COMMANDER 400 INITIALIZATION SEQUENCE
AND ERROR CODE EXPLANATIONS
When the Commander 400 is started, the display flashes several messages during initializa-
tion. They usually go by so fast you cannot see them. Each message correlates to an ini-
tialization test that the microcontroller program runs. No message should be present for more
than a few seconds before the next message appears. If any of these initialization messages
remain on the display, there is a problem. The microcontroller’s program will not advance past
that test.
The initialization period is over immediately after the “---” disappears from the display. Once
past the initialization, under normal circumstances, the unit displays a welding current preset
determined by the position of the front panel control knobs and switches. If a later control
board (G2713-2 or -3 is in place, the message “cdr 400 rEAdy” scrolls across the display.
Initialization is over after this message finishes scrolling. In the “Stick & Wire” model a preset
voltage or actual voltage, as well as current, may be displayed after initialization.
If the microcontroller detects an error, the error code will show on the display first and then the
unit may shut down. Use the “Error Code Explanations” on the following pages to aid in trou-
bleshooting diagnosis.
If the unit begins to shut down first and then the error code appears, this is not
a microcon-
troller initiated shutdown. In this case the unit has shut down due to lack of fuel, engine fail-
ure, etc.