Filter
Top Products
TROUBLESHOOTING & REPAIR
F-106 F-106
COMMANDER 400
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
ENGINE, STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F.49 – FUEL TANK REMOVAL DETAILS
FUEL LEVEL SENSOR
FUEL RETURN LINE
U-BOLT (2)
PREPARATION AND LEAD REMOVAL
PROCEDURE
1. Turn the engine off.
2. Using the 3/8" and 1/2" wrenches, remove the
battery cover and disconnect the battery.
Remove the battery by sliding it out.
3. Perform the Case Cover Removal
Procedure (including removing the front
shroud).
4. Using the 3/8" wrench, remove leads #242E
and #229 from the fuel level sensor. See
Figure F.49. Label the leads for reassembly.
5. Turn the fuel off at the shutoff valve. Remove
and plug the fuel return line. See Figure F.49.
6. Remove and plug the lower fuel line. See
Figure F.49.
7. Using the 9/16" socket wrench, remove the
four nuts, washers and rubber washers from
the fuel tank mounting U-bolts. See Figure
F.49.
8. Carefully remove the U-bolts and lift the fuel
tank away from the machine.