Filter
Top Products
TROUBLESHOOTING & REPAIR
F-108 F-108
COMMANDER 400
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
ENGINE, STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F.52 – SHUTDOWN SOLENOID LEAD REMOVAL
PULL-IN COIL
(LARGER TERMINALS
EACH SIDE
#225 AND #262)
HOLD-IN COIL
(SMALLER TERMINALS
EACH SIDE
#224 AND #240)
IDLER
SOLENOID
SHUTDOWN
SOLENOID
12. Label and remove the four leads #224, #240,
#225 and #262 from the shutdown solenoid.
See Figure F.52. Cut any necessary cable
ties.
13. Label and remove leads #226, #237, #227
and #254 from the idler solenoid. See Figure
F.53 Cut any necessary cable ties.
FIGURE F.53 – IDLER SOLENOID LEAD REMOVAL
PULL-IN COIL
(LARGER TERMINALS
TOP AND BOTTOM
#227 AND #254)
HOLD-IN COIL
(SMALLER
TERMINALS
TOP AND BOTTOM
#226 AND #237)
IDLER
SOLENOID
SHUTDOWN
SOLENOID