Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
139
disable - Disable the IP interface.
proxy_arp - (Optional) Enable or disable the proxy ARP. This is for the IPv4 function. The default
is disabled.
enable - Enable the proxy ARP.
disable - Disable the proxy ARP.
local - (Optional) This setting controls whether the system provides the proxy reply for the ARP
packets destined for IP addresses located in the same interface as the received interface.
When proxy ARP is enabled for an interface, the system will do the proxy reply for the ARP
packets destined for IP addresses located on a different interface. For ARP packets destined
for IP address located on the same interface, the system will check this setting to determine
whether to reply. The default is disabled.
enable - Enable the local proxy ARP function.
disable - Disable the local proxy ARP function.
bootp - Allows the selection of the BOOTP protocol for the assignment of an IP address to the
switch’s System IP interface.
dhcp - Allows the selection of the DHCP protocol for the assignment of an IP address to the
switch’s System.
ipv6 - The following are IPv6-related parameters.
ipv6address - The IPv6 address and subnet prefix of the IPV6 address to be created.
<ipv6networkaddr> - The IPv6 address and subnet prefix of the IPv6 address to be
created.
state - Enable or disable the IPv6 state of the IP interface.
enable - Enable the IPv6 state of the IP interface.
disable - Disable the IPv6 state of the IP interface.
ip_mtu - Specifies the IP Layer MTU value used.
<value 512-1712> - Enter the IP Layer MTU value used here. The value must be between
512 and 1712.
ipv4 state - The state of the IPv4 interface.
enable - Enable the IPv4 state of the IP interface.
disable - Disable the IPv4 state of the IP interface.
dhcpv6_client - Specifies the DHCPv6 client state of the interface.
enable - Specifies that the DHCPv6 client state of the interface will be enabled.
disable - Specifies that the DHCPv6 client state of the interface will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the System IP interface:
DGS-3420-28SC:admin#config ipif System vlan v1
Command: config ipif System vlan v1
Success.
DGS-3420-28SC:admin#
11-2 create ipif
Description
This command is used to create an L3 interface. This interface can be configured with IPv4 or IPv6
addresses. Currently, it has a restriction: an interface can have only one IPv4 address defined. But
it can have multiple IPv6 addresses defined. Thus, the multinetting configuration of IPv4 must be
done through creation of a secondary interface on the same VLAN, instead of directly configuring