Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
928
Binding objects:
(1) swMultiImageVersion
agentCfgOperCompleteTrap
The trap is sent when the configuration is
completely saved, uploaded or downloaded
Binding objects:
unitID
agentCfgOperate
agentLoginUserName
1.3.6.1.4.1.171.12.1.
7.2.0.9
Gratuitous ARP
agentGratuitousARPTrap
The trap is sent when IP address conflicted.
Binding objects:
(1) ipaddr
(2) macaddr
(3) portNumber
(4) agentGratuitousARPInterfaceName
1.3.6.1.4.1.171.12.1.
7.2.0.5
Stacking swUnitInsert Unit Hot Insert notification.
Binding objects:
(1) swUnitMgmtId.
(2) swUnitMgmtMacAddr.
1.3.6.1.4.1.171.12.11
.2.2.1.0.1
swUnitRemove
Unit Hot Remove notification.
Binding objects:
(1) swUnitMgmtId.
(2) swUnitMgmtMacAddr.
1.3.6.1.4.1.171.12.11
.2.2.1.0.2
swUnitFailure
Unit Failure notification.
Binding objects:
(1) swUnitMgmtId.
1.3.6.1.4.1.171.12.11
.2.2.1.0.3
swUnitTPChange
The stacking topology change notification.
Binding objects:
(1) swStackTopologyType
(2) swUnitMgmtId
(3) swUnitMgmtMacAddr
1.3.6.1.4.1.171.12.11
.2.2.1.0.4
swUnitRoleChange
The stacking unit role change notification.
Binding objects:
(1) swStackRoleType
(2) swUnitMgmtId
1.3.6.1.4.1.171.12.11
.2.2.1.0.5
Port Security
swL2PortSecurityViolationTrap
When the port security trap is enabled, new
MAC addresses that violate the pre-defined
port security configuration will trigger trap
messages to be sent out.
Binding objects:
(1)swPortSecPortIndex
(2)swL2PortSecurityViolationMac
1.3.6.1.4.1.171.11.11
9.X.2.100.1.2.0.2,(X
:module ID)
Safeguard
swSafeGuardChgToNormal
This trap indicates system change operation
mode from axhausted to normal.
Binding objects:
(1) swSafeGuardCurrentStatus
1.3.6.1.4.1.171.12.19
.4.1.0.2
swSafeGuardChgToExhausted
This trap indicates System change operation
mode from normal to exhausted.
Binding objects:
(1) swSafeGuardCurrentStatus
1.3.6.1.4.1.171.12.19
.4.1.0.1
LBD
swPortLoopOccurred The trap is sent when loop back is detected
under port-based mode.
Binding objects:
(1) swLoopDetectPortIndex
1.3.6.1.4.1.171.12.41
.10.0.1
swPortLoopRestart
The trap is sent when port recovered from
LBD blocked state under port-based mode.
Binding objects:
(1) swLoopDetectPortIndex
1.3.6.1.4.1.171.12.41
.10.0.2
swVlanLoopOccurred
The trap is sent when loop back is detected
under VLAN-based mode.
Binding objects:
(1) swLoopDetectPortIndex
(2) swVlanLoopDetectVID
1.3.6.1.4.1.171.12.41
.10.0.3
swVlanLoopRestart The trap is sent when port recovered from
LBD blocked state under VLAN-based
mode.
Binding objects:
(1) swLoopDetectPortIndex
(2) swVlanLoopDetectVID
1.3.6.1.4.1.171.12.41
.10.0.4
BPDU Attack
Protection
swBpduProtectionUnderAttacking
Trap
BPDU attack happened, enter drop / block /
shutdown mode.
Binding objects:
(1)swBpduProtectionPortIndex
(2)swBpduProtectionPortMode
1.3.6.1.4.1.171.12.76
.4.0.1
swBpduProtectionRecoveryTrap
BPDU attack automatically recover
1.3.6.1.4.1.171.12.76