Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
317
state - Specifies the propagation state of the topology change for the sub-ring.
enable - Enable the propagation state of the topology change for the sub-ring.
disable
- Disable the propagation state of the topology change for the sub-ring.
add - Specifies the add a topology change propagation rule.
delete - Specifies the delete a topology change propagation rule.
sub_ring - Specifies the sub-ring configuration.
raps_vlan - Specify the R-APS VLAN.
<vlanid> - Enter the R-APS VLAN ID used here.
revertive - Specifies the revertive mode state.
enable - Specifies that the revertive mode will be enabled..
disable - Specifies that the revertive mode will be disabled.
timer - Configure the ERPS timers for a specific R-APS VLAN.
holdoff_time - Specify the holdoff time of the R-APS function.
<value 0-10000> - Specify the time between 0 and 10000. The default hold off time is 0
milliseconds.
guard_time - Specify the guard time of the R-APS function.
<value 10-2000> - Specify the time between 10 and 2000. The default guard time is 500
milliseconds.
wtr_time - Specify the WTR time of the R-APS function.
<value 5-12> - Specify the time between 5 and 12. The default WTR time is 5 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the R-APS west ring port parameter to 5:
DGS-3420-28SC:admin#config erps raps_vlan 4094 ring_port west 5
Command: config erps raps_vlan 4094 ring_port west 5
Success.
DGS-3420-28SC:admin#
To set the R-APS east ring port parameter to 7:
DGS-3420-28SC:admin#config erps raps_vlan 4094 ring_port east 7
Command: config erps raps_vlan 4094 ring_port east 7
Success.
DGS-3420-28SC:admin#
To set the R-APS RPL parameter:
DGS-3420-28SC:admin#config erps raps_vlan 4094 rpl_port west
Command: config erps raps_vlan 4094 rpl_port west
Success.
DGS-3420-28SC:admin#config erps raps_vlan 4094 rpl_owner enable
Command: config erps raps_vlan 4094 rpl_owner enable