Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
655
67-7 config ptp ports
Description
This command is used to configure the per port state of the PTP clock.
PTP port active state should meet the following three conditions:
• The global PTP state is enabled.
• The port PTP state is enabled.
• The port is not blocked, if the stp state is enabled.
Format
config ptp ports [<portlist> | all] state [enable | disable]
Parameters
ports - Specifies the list of port used for this configuration.
<portlist> - Enter the list of port used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
state - Specifies the port state of the PTP clock function.
enable - Specifies that the port state of the PTP clock function will be enabled.
disable - Specifies that the port state of the PTP clock function will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable PTP on ports 1:1-1:4:
DGS-3420-28SC:admin# config ptp ports 1:1-1:4 state enable
Command: config ptp ports 1:1-1:4 state enable
Success.
DGS-3420-28SC:admin#
67-8 config ptp boundary ports
Description
This command is used to configure the attributes of the PTP boundary clock. The configuration
takes effect when the PTP device is a boundary type.
Format
config ptp boundary ports [<portlist> | all] {announce [interval <sec 1-16> | timeout <value
2-10>] | sync_interval [half_second | <sec 1-2>] | delay_req_interval <value 0-5> |
pdelay_req_interval <sec 1-32> | delay_mechanism [e2e | p2p]}(1)