xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
224
Format
debug ripng flag [{interface | packet [all | rx | tx] | route} | all] state [enable | disable]
Parameters
interface - (Optional) Specifies the state of the RIPng interface debug. The default setting is
disabled.
packet - (Optional) Specifies which packets should be set with debug flags.
all - Specifies to set all packets with debug flags.
rx - Specifies to set inbound packets with debug flag.
tx - Specifies to set outbound packets with debug flag.
route - (Optional) Specifies the state of the RIPng route debug. The default setting is disabled.
all - Specifies to set all debug flags.
state - Specifies the designated flags state.
enable - Specifies that the designated flags state will be enabled.
disable - Specifies that the designated flags state will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the RIPng debug:
DGS-3420-28SC:admin# debug ripng state enable
Command: debug ripng state enable
Success.
DGS-3420-28SC:admin#
After enabling RIPng on an interface, the following information may appear when the interface
state changes.
The RIPng interface System has changed the link state to down.
19-28 debug ripng show flag
Description
This command is used to display the RIPng debug flag setting.
Format
debug ripng show flag