Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
160
Format
create cfm mep <string 32> mepid <int 1-8191> md [<string 22> | md_index <uint 1-
4294967295>] ma [<string 22> | ma_index <uint 1-4294967295>] direction [inward | outward]
port <port>
Parameters
<string 32> - Enter the MEP name used here. It is unique among all MEPs configured on the
device. The name can be up to 32 characters long.
mepid - Specify the MEP MEPID. It should be configured in the MA’s MEPID list.
<int 1-8191> - Specify the MEP MEPID between 1 and 8191.
md - Specify the maintenance domain name.
<string 22> - Specify the maintenance domain name. The maximum length is 22 characters.
md_index - Specify the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
ma - Specify the maintenance association name.
<string 22> - Specify the maintenance association name. The maximum length is 22
characters.
ma_index - Specify the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must be between 1 and 4294967295.
direction - Specify the MEP direction.
inward - Inward facing (up) MEP.
outward - Outward facing (down) MEP.
port
- Specify the port number. This port should be a member of the MA’s associated VLAN.
<port>
- Specify a port.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an MEP:
DGS-3420-28SC:admin#create cfm mep mep1 mepid 1 md op_domain ma op1 direction
inward port 2
Command: create cfm mep mep1 mepid 1 md op_domain ma op1 direction inward port
2
Success.
DGS-3420-28SC:admin#
14-6 config cfm mep
Description
This command is used to configure the parameters of an MEP. An MEP may generate five types of
Fault Alarms, as shown below by their priorities from high to low:
1. Cross-connect CCM Received: priority 5
2. Error CCM Received: priority 4
3. Some Remote MEPs Down: priority 3
4. Some Remote MEP MAC Status Errors: priority 2