Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
159
mip - (Optional) This is the control creation of MIPs.
none - Do not create MIPs.
auto - MIPs can always be created on any port in this MA if that port is not configured with an
MEP of that MA.
explicit - MIPs can be created on any ports in this MA only if the next existing lower level has
an MEP configured on that port, and that port is not configured with an MEP of this MA.
defer - Inherit the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
sender_id - (Optional) This is the control transmission of the sender ID TLV.
none - Do not transmit the sender ID TLV. This is the default value.
chassis - Transmit the sender ID TLV with the chassis ID information.
manage - Transmit the sender ID TLV with the manage address information.
chassis_manage - Transmit the sender ID TLV with the chassis ID information and the
manage address information.
defer - Inherit the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
ccm_interval - (Optional) Specify the CCM interval.
100ms - 100 milliseconds. Not recommended in CFM software mode.
1sec - One second.
10sec - Ten seconds. This is the default value.
1min - One minute.
10min
- Ten minutes.
mepid_list - (Optional) Specify the MEPIDs contained in the maintenance association.
add - Add MEPID(s).
delete - Delete MEPID(s).
<mepid_list 1-8191> - Specify the MEPIDs contained in the maintenance association. The
range of the MEPID is 1 to 8191.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the parameters of a maintenance association:
DGS-3420-28SC:admin#config cfm ma op1 md op_domain vlanid 1 ccm_interval 1sec
Command: config cfm ma op1 md op_domain vlanid 1 ccm_interval 1sec
Success.
DGS-3420-28SC:admin#
14-5 create cfm mep
Description
This command is used to create an MEP entry. Different MEPs in the same MA must have a
different MEPID. To put MD name, MA name, and MEPID together identifies an MEP. Different
MEPs on the same device must have a different MEP name. Before creating an MEP, its MEPID
should be configured in the MA’s MEPID list.