Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
567
<value 0-7> - Specify the remap priority (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
none - If none is specified, the packet’s original priority will be used. The default setting is
none.
replace_priority - (Optional) Specify that the packet’s priority will be changed by the switch,
based on the remap priority. This flag will only take effect when the remap priority is set.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an MLD snooping multicast VLAN with the VLAN name mv1 and the VID 2:
DGS-3420-28SC:admin#create mld_snooping multicast_vlan mv1 2
Command: create mld_snooping multicast_vlan mv1 2
Success.
DGS-3420-28SC:admin#
56-2 config mld_snooping multicast_vlan
Description
This command is used to configure MLD snooping multicast VLAN parameters. The member port
list and source port list cannot overlap. However, the member port of one multicast VLAN can
overlap with another multicast VLAN. The multicast VLAN must be created first using the create
mld_snooping multicast_vlan command before the multicast VLAN can be configured.
Format
config mld_snooping multicast_vlan <vlan_name 32> {[add | delete] [member_port
<portlist> | [source_port <portlist> | untag_source_port <portlist>] | tag_member_port
<portlist>] | state [enable | disable] | replace_source_ipv6 <ipv6addr> | remap_priority
[<value 0-7> | none] {replace_priority}}(1)
Parameters
<vlan_name 32> - Specify the name of the multicast VLAN to be configured. Each multicast
VLAN is given a name that can be up to 32 characters.
add - Specify to add a port.
delete - Specify to delete a port.
member_port - Specify member port of the multicast VLAN. The specified range of ports will
become untagged members of the multicast VLAN.
<portlist> - Specify a range of ports to be configured.
source_port - Specify source port where the multicast traffic is entering the Switch.
<portlist> - Specify a range of ports to be configured.
untag_source_port - Specify the untagged source port where the multicast traffic is entering the
Switch. The PVID of the untagged source port is automatically changed to the multicast VLAN.
Source ports must be either tagged or untagged for any single multicast VLAN, i.e. both types
cannot be members of the same multicast VLAN
<portlist> - Specify a range of ports to be configured.