Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
853
Chapter 93
Voice VLAN
Commands
enable voice_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
disable voice_vlan
config voice_vlan priority <int 0-7>
config voice_vlan oui [add | delete] <macaddr> <macmask> {description <desc 32>}
config voice_vlan ports [<portlist> | all] [state [enable | disable] | mode [auto | manual]]
config voice_vlan log state [enable | disable]
config voice_vlan aging_time <min 1-65535>
show voice_vlan
show voice_vlan lldp_med voice_device
show voice_vlan oui
show voice_vlan ports {<portlist>}
show voice_vlan voice_device {ports <portlist>}
93-1 enable voice_vlan
Description
This command is used to enable the global voice VLAN function on a switch. To enable the voice
VLAN, the voice VLAN must be also assigned. At the same time, the VLAN must be an existing
static 802.1Q VLAN. To change the voice VLAN, the user must disable the voice VLAN function,
and re-issue this command. By default, the global voice VLAN state is disabled.
Format
enable voice_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
Parameters
<vlan_name 32>
- Specify the name of the voice VLAN. The maximum length is 32 characters.
The name must be an existing static VLAN name.
vlanid - Specify the VLAN ID of the voice VLAN. The ID must be an existing static VLAN ID.
<vlanid 1-4094> - Specify the VLAN ID between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable voice VLAN named v2: