xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
143
Restrictions
None.
Example
To display IP interface settings:
DGS-3420-28SC:admin#show ipif
Command: show ipif
IP Interface : System
VLAN Name : default
Interface Admin State : Enabled
DHCPv6 Client State : Disabled
Link Status : LinkUp
IPv4 Address : 192.168.69.123/24 (Manual) Primary
Proxy ARP : Disabled (Local : Disabled)
IPv4 State : Enabled
IPv6 State : Enabled
IP MTU : 1500
IP Interface : mgmt_ipif
Status : Enabled
IP Address : 192.168.0.1
Subnet Mask : 255.255.255.0
Gateway : 0.0.0.0
Link Status : Link Down
Total Entries: 2
DGS-3420-28SC:admin#
11-7 config out_band_ipif
Description
This command is used to configure the out of band management port settings.
Format
config out_band_ipif {ipaddress <network_address> | state [enable | disable] | gateway
<ipaddr>} (1)
Parameters
ipaddress - Specify the IP address of the interface. The parameter must include the mask.
<network_address> - Specify the IP address of the interface. The parameter must include
the mask.
state – Specify the interface status.
enable - Specify to enable the interface.
disable - Specify to disable the interface.
gateway - Specify the gateway IP address of the out-of-band management network.