Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
203
Chapter 19
Debug Software
Command List
debug address_binding [event | dhcp | all] state [enable | disable]
no debug address_binding
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show error_reboot state
debug stp clear counter {ports [<portlist> | all]}
debug stp config ports [<portlist> | all] [event | bpdu | state_machine | all] state [disable | brief |
detail]
debug stp show counter {ports [<portlist> | all]}
debug stp show flag {ports <portlist>}
debug stp show information
debug stp state [disable | enable]
debug dhcpv6_client state enable
debug dhcpv6_client state disable
debug dhcpv6_client output [buffer | console]
debug dhcpv6_client packet {all | receiving | sending} state [enable | disable]
debug dhcpv6_relay state enable
debug dhcpv6_relay state disable
debug dhcpv6_relay hop_count state [enable | disable]
debug dhcpv6_relay output [buffer | console]
debug dhcpv6_relay packet {all | receiving | sending} state [enable | disable]
debug dhcpv6_server packet [all | receiving | sending] state [enable | disable]
debug dhcpv6_server state disable
debug dhcpv6_server state enable
debug ripng flag [{interface | packet [all | rx | tx] | route} | all] state [enable | disable]
debug ripng show flag
debug ripng state disable
debug ripng state enable
debug show status {module <module_list>}
debug show address_binding binding_state_table [nd_snooping | dhcpv6_snooping]
19-1 debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]