Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
835
<filter_string 80> - Specify a filter string enclosed by the quotation mark symbol.
<filter_string 80> - Specify a filter string enclosed by the quotation mark symbol.
log_toTFTP - Used to upload a log file from the device to a TFTP server.
<ipaddr> - Specify the IP address of the TFTP server.
<ipv6addr> - Specify the IPv6 address of the TFTP server.
<domain_name 255> - Enter the domain name of the TFTP server here. This name can be
up to 255 characters long.
dest_file - Specifies the path name on the TFTP server.
<path_filename 64> - Specify the path name on the TFTP server. It can be a relative path
name or an absolute path name.
attack_log_toTFTP - Used to upload the attack log to a TFTP server.
<ipaddr> - Specify the IP address of the TFTP server.
<ipv6addr> - Specify the IPv6 address of the TFTP server.
<domain_name 255> - Enter the domain name of the TFTP server here. This name can be
up to 255 characters long.
dest_file - Specify the path name on the TFTP server.
<path_filename 64> - Specify the path name on the TFTP server. It can be a relative path
name or an absolute path name.
unit - (Optinal) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id> - Enter the unit ID used here.
firmware_toTFTP - Used to upload firmware from the device to a TFTP server.
<ipaddr> - Specify the IP address of the TFTP server.
<ipv6addr> - Specify the IPv6 address of the TFTP server.
<domain_name 255> - Enter the domain name of the TFTP server here. This name can be
up to 255 characters long.
dest_file - Specify the path name on the TFTP server.
<path_filename 64> - Specify the path name on the TFTP server.
unit - (Optinal) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id>
- Enter the unit ID used here.
src_file - (Optional) Specify an absolute path name on the device file system. If the path name is
not specified, it refers to the boot up image.
<pathname> - Specify an absolute path name on the device file system. If the path name is
not specified, it refers to the boot up image.
Restrictions
Only Administrator, Operator level users can issue this command.
Example
To upload firmware from a file system device to a TFTP server:
DGS-3420-28SC:admin#upload firmware_toTFTP 10.1.1.1 dest_file D:\firmware.had
src_file 2.00.009.had
Command: upload firmware_toTFTP 10.1.1.1 dest_file D:\firmware.had src_file
2.00.009.had
Connecting to server.................. Done.
Upload firmware....................... Done.
DGS-3420-28SC:admin#
To upload the current configuration file to a TFTP server: