Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
628
<min 3-30> - Enter a value between 5 and 30 minutes.
disable – Specifies that when the action is shutdown and the countdown is disabled, when the
Switch detects a storm, it will shutdown the port directly.
time_interval - The sampling interval of received packet counts. This parameter is meaningless
for dropping packets is selected as action.
<value 5-600> - Specify the value between 5 and 600.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure traffic control and state:
DGS-3420-28SC:admin#config traffic control 1-10 broadcast enable action
shutdown threshold 640 time_interval 10
Command: config traffic control 1-10 broadcast enable action shutdown threshold
640 time_interval 10
Success.
DGS-3420-28SC:admin#
62-2 config traffic control auto_recover_time
Description
This command is used to configure the traffic auto recover time that allowed for a port to recover
from shutdown forever status. The time allowed for auto recovery from shutdown for a port. The
default value is 0, so no auto recovery is possible; the port remains in shutdown forever mode.
This requires manual entry of the CLI command “config ports [ <portlist> | all ] state enable" to
return the port to a forwarding state. The default value is 0, which means disable auto recover
mode, shutdown forever.
Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Parameters
<min 0> - Enter the automatic recovery time used here. This value will specifies the time to be 0
otherwise known as 'no recovery mode'.
<min 1-65535> - Enter the automatic recovery time used here. This value must be between 1
and 65535 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the auto recover time to 5 minutes: