Filter
Top Products
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
646
Parameters
ports - (Optional) Specifies the list of ports to be displayed here.
<portlist> - Enter the list of ports, used for the display, here.
If no parameter is specified, the system will display the status for all the ports.
Restrictions
None.
Example
To display PoE port configurations on port 1 to 6:
DGS-3420-28PC:admin# show poe ports 1:1-1:6
Command: show poe ports 1:1-1:6
Port State Priority Power Limit(mW) Time Range
Class Power(mW) Voltage(decivolt) Current(mA)
Status
===============================================================================
1:1 Enabled Critical 4200 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:2 Enabled Critical 4200 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:3 Enabled Critical 4200 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:4 Enabled Critical 4200 (Class 1)
0 0 0 0
OFF : Interim state during line detection
1:5 Enabled Low 7000 (User-defined)
0 0 0 0
OFF : Interim state during line detection
1:6 Enabled Low 7000 (User-defined)
0 0 0 0
OFF : Interim state during line detection
DGS-3420-28PC:admin#
65-4 show poe system
Description
This command is used to display the settings and actual values of the whole PoE system.
Note: This command is only available to Switches in the DGS-3420 Series that suppport Power
over Ethernet.
Format
show poe system {units <unitlist>}