xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
402
Example
To show an IP tunnel interface’s information (Tunnel name is “tn2”):
DGS-3420-28SC:admin# show ip_tunnel tn2
Command: show ip_tunnel tn2
Tunnel Interface : tn2
Interface Admin State : Enabled
Tunnel Mode : Manual
IPv6 Global Unicast Address : 2000::1/64
Tunnel Source : 1.0.0.1
Tunnel Destination : 1.0.0.2
DGS-3420-28SC:admin#
39-7 enable ip_tunnel
Description
This command is used to enable a single specified IP tunnel or all IP tunnels on the Switch.
Format
enable ip_tunnel {<tunnel_name 12>}
Parameters
<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be
up to 12 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable an IP tunnel interface (Tunnel name is “tn2”):
DGS-3420-28SC:admin# enable ip_tunnel tn2
Command: enable ip_tunnel tn2
Success.
DGS-3420-28SC:admin#
39-8 disable ip_tunnel
Description
This command is used to disable a single specified IP tunnel or all IP tunnels on the Switch.