Filter
Top Products
C-8
ACCESSORIES
C-8
POWER WAVE 455/POWER FEED 10
DUAL PROCEDURE SWITCH OPTIONS
K683-3 DUAL PROCEDURE SWITCH
Kit includes gun switch and mountings for Lincoln
Innershield and Magnum guns, with 15 ft (4.5 m)
control cable and 5-pin plug with two leads to con-
nect to gun trigger.
Connect the 5-pin plug of the K683-3 Dual Procedure
Switch to the Power Feed 10 wire feeder trigger/dual
procedure 5-socket receptacle.
The two lead plug cord extending out of the 5-pin
plug of the Dual Procedure Switch is to be connected
to the two trigger leads of the welding gun per
instructions shipped with the kit.
K683-1 DUAL PROCEDURE SWITCH
The K683-3 Dual Procedure Switch is the recom-
mended method of obtaining dual procedure; but if it
is desired to use an existing K683-1 with the Power
Feed 10, it can be done. A K683-1 Dual Procedure
Switch can be used on the Power Feed 10 if a K686-
2 adapter is used. The K682-1 kit includes gun
switch and mountings for Lincoln Innershield and
Magnum guns, with 15 ft (4.5 m) control cable and 3-
pin plug. K686-2 adapter permits 3-pin plug and 5-
pin gun trigger plug to be connected to Power Feed
10 5-pin trigger/dual procedure receptacle.
GAS AND WATER KITS
K590-5 WATER CONNECTION KIT
(FOR DRIVE ONLY)
Install per the instructions shipped with the kit.
K1536-1 WATER FLOW SENSOR KIT
Install per the instructions shipped with the kit.
K659-1 GAS GUARD REGULATOR
Adjustable flow regulator with removable adjuster key
for CO
2
and Argon blend gases. Mounts onto feeder
inlet, and reduces gas waste and arc start “blow” by
reducing surge caused by excess pressure in supply
hose.
Install the 5/8-18 male outlet of the regulator to the
5/8-18 female gas inlet on the back panel of the wire
drive. Secure fitting with flow adjuster key at top.
Attach gas supply to 5/8-18 female inlet of regulator.
CHASSIS OPTIONS
K1557-1 SWIVEL PLATFORM
The K1557-1 Swivel platform attaches to the power
source. This kit includes a feeder adapter plate that
allows the feeder to rotate on top of the power
source. The feeder can be easily separated from the
swivel mount at any time. This option is compatible
with the K1556-1 Light Duty Caster Kit.
K1556-1 LIGHT DUTY CASTER KIT
This option provides four casters and all required
hardware to mount it to the Power Feed 10. This
option is compatible with the K1557-1 Swivel
Platform.
K1574-1 SECURITY DOOR (LARGE)
K1574-1 Security Door Installation into the Control
Box cabinet.
1. Turn off power.
2. Unlatch and swing open the small door. Remove
the two screws from the horizontal hinge rod.
Save the screws.
3. While holding the door so it doesn’t fall, slide the
rod out sideways releasing the door.
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC