Filter
Top Products
Chapter 5 Device Network Settings
Vantage CNM User’s Guide
104
5.3.10 Advanced Modem Setup (Prestige)
Click Edit in the Advanced Modem Setup field. See Section 5.3.5 on page 92 for the
configuration of this screen.
5.4 Wireless Card
This section shows you how to configure the Wireless Card screens. These screens may vary
depending on which model you’re configuring. Please see the device’s User’s Guide for more
information about any of these screens or fields.
5.4.1 Wireless and Wireless Security Settings
This screen depends on the device type and firmware version.
Use this screen to configure wireless and wireless security settings. To open this screen, click
Device Operation > Device Configuration > Network > Wireless Card > Wireless Card.
Nailed-Up
Connection
Select Nailed-Up Connection when you want your connection up all the time.
The device will try to bring up the connection automatically if it is disconnected.
Connect on Demand Select Connect on Demand when you don't want the connection up all the
time and specify an idle time-out in the Max Idle Timeout field.
Max Idle Timeout Specify an idle time-out in the Max Idle Timeout field when you select
Connect on Demand. The default setting is 0, which means the Internet
session will not timeout.
Budget
The configuration in the Budget fields has priority over your
Connection settings.
Allocated Budget Type the amount of time (in minutes) that the dial backup connection can be
used during the time configured in the Period field. Set an amount that is less
than the time period configured in the Period field. If you set the Allocated
Budget to 0, you will not be able to use the dial backup connection.
Period Type the time period (in hours) for how often the budget should be reset. For
example, to allow calls to this remote node for a maximum of 10 minutes every
hour, set the Allocated Budget to 10 (minutes) and the Period to 1 (hour). If
you set the Period to 0, there is no budget control and the device uses the
Connection settings.
Back Click Back to return to the previous screen.
Apply Click Apply to save the changes.
Reset Click Reset to begin configuring this screen afresh.
Table 31 Device Operation > Device Configuration > Network > WAN Backup > Advanced
(Prestige) (continued)
LABEL DESCRIPTION