Filter
Top Products
Chapter 5 Device Network Settings
Vantage CNM User’s Guide
81
The following table describes the labels in this screen.
Table 22 Device Operation > Device Configuration > Network > WAN > WAN1/2 - PPPoE
(ZyNOS ZyWALL with two WAN ports)
LABEL DESCRIPTION
ISP Parameters
for Internet
Access
Encapsulation The PPPoE choice is for a dial-up connection using PPPoE. The router supports
PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is an IETF standard (RFC
2516) specifying how a personal computer (PC) interacts with a broadband modem
(for example, DSL, cable, wireless, etc.) connection. Operationally, PPPoE saves
significant effort for both the end user and ISP/carrier, as it requires no specific
configuration of the broadband modem at the customer site. By implementing
PPPoE directly on the router rather than individual computers, the computers on
the LAN do not need PPPoE software installed, since the router does that part of
the task. Further, with NAT, all of the LAN's computers will have access.
Service Name Type the PPPoE service name provided to you. PPPoE uses a service name to
identify and reach the PPPoE server.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above.
Retype to
confirm
Password
Type your password again to make sure that you have entered is correctly.
Nailed-Up
Connection
Select this if you do not want the connection to time out.
Idle Timeout This value specifies the time in seconds that elapses before the device
automatically disconnects from the PPPoE server.
Authentication
Type
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
CHAP/PAP - Your Vantage CNM accepts either CHAP or PAP when requested by
this remote node.
CHAP - Your Vantage CNM accepts CHAP only.
PAP - Your Vantage CNM accepts PAP only.
WAN IP Address
Assignment
Get
automatically
from ISP
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Use Fixed IP
Address
Select this option If the ISP assigned a fixed IP address.
My WAN IP
Address
Enter your WAN IP address in this field if you selected Use Fixed IP Address.
Private This parameter determines if the device will include this route to a remote node in
its RIP broadcasts.
Select this check box to keep this route private and not included in RIP broadcasts.
Clear this check box to propagate this route to other hosts through RIP broadcasts.
Advanced Setup