Filter
Top Products
Chapter 5 Device Network Settings
Vantage CNM User’s Guide
97
Figure 44 Device Operation > Device Configuration > Network > WAN > Setup (Prestige)
The following table describes the fields in this screen.
Table 29 Device Operation > Device Configuration > Network > WAN > Setup (Prestige)
LABEL DESCRIPTION
Name Enter the name of your Internet Service Provider, for example, MyISP.
This information is for identification purposes only.
Mode Select Routing from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down
list box. Choices vary depending on the mode you select in the Mode
field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET
ENCAP or PPPoE.
Multiplex Select the method of multiplexing used by your ISP from the drop-down
list. Choices are VC or LLC.
Virtual Circuit ID VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a
virtual circuit. Refer to the appendix for more information.
VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.