Filter
Top Products
Chapter 6 Device Security Settings
Vantage CNM User’s Guide
157
6.7 IDP
This section shows you how to configure the IDP screens. These screens may vary depending
on which model you’re configuring. Please see the device’s User’s Guide for more
information about any of these screens or fields.
6.8 General Setup
Use this screen to enable IDP on the device and choose what interface(s) you want to protect
from intrusions. To open this screen, click a device, click Device Operation in the menu bar
and then click Device Configuration > Security > IDP > General in the navigation panel.
Figure 71 Device Operation > Device Configuration > Security > IDP > General
The following table describes the labels in this screen.
Table 61 Device Operation > Device Configuration > Security > IDP > General
LABEL DESCRIPTION
General Setup
Enable Intrusion
Detection and
Prevention
Select this check box to enable IDP on the device. When this check box is
cleared the device is in IDP “bypass” mode and no IDP checking is done.
Turbo Card This field displays whether or not a device’s Turbo Card is installed.
Note: You cannot configure and save the IDP or Anti-Virus
screens if the device’s Turbo Card is not installed.