Filter
Top Products
Chapter 7 Device Advanced Settings
Vantage CNM User’s Guide
203
7.7 DNS
This section shows you how to configure the DNS screens. These screens may vary depending
on which model you’re configuring. Please see the device’s User’s Guide for more
information about any of these screens or fields.
7.8 Address Record
Use this screen to map a fully-qualified domain name (FQDN) to an IP address. To open this
screen, click a device, click Device Operation in the menu bar and then click Device
Configuration > Advanced > DNS > Address Record in the navigation panel.
Figure 96 Device Operation > Device Configuration > Advanced > DNS > Address Record
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is an immediate neighbor of the
device that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as the device; over the WAN, the gateway
must be the IP address of one of the Remote Nodes.
Metric Metric represents the cost of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
Private This parameter determines if the device will include this route to a remote node in
its RIP broadcasts.
Select this check box to keep this route private and not included in RIP broadcasts.
Clear this check box to propagate this route to other hosts through RIP broadcasts.
Apply Click Apply to save your changes back to the device.
Cancel Click Cancel to return to the previous screen.
Table 86 Device Operation > Device Configuration > Advanced > Static Route > Edit
LABEL DESCRIPTION