Filter
Top Products
4-9
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 4 Managing Chassis
Chassis Configuration
Starting Global Performance Logging
Global performance logging, when set, collects performance information on GRPs and interfaces on a
specified chassis. Performance data can then be viewed through performance menus or through the
Performance Manager.
Note Performance logging can also be started on a per module (GRP) or physical interface basis. For details
on how to start performance logging for a selected module (GRP), see “Module Performance” section
on page 5-9. For details on how to start performance logging for a selected physical interface (such as
Ethernet, ATM, or DS-3), see “Starting Performance Logging for a Selected Interface” section on
page 10-5.
If you start global performance logging on a chassis, all subchassis objects are placed into the
performance logging on state. However, performance data is only collected for GRPs and interfaces, so
any other modules will not collect performance data, despite having a state of performance logging on.
Note Global Performance Logging can use a lot of bandwidth, so use discretion.
To start global performance logging for a selected chassis, proceed as follows:
Step 1 Open the Chassis Configuration window. See “Viewing the Chassis Configuration Window” section on
page 4-7 for further details.
Step 2 Select the relevant Chassis from the list displayed at the left of the window.
Step 3 Click Start to begin performance logging on the selected chassis. An Action Report window appears:
Figure 4-4 Action Report Window