Filter
Top Products
7-21
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 7 Interface Profiles
Creating a SRP Side Profile
SONET Overhead
Path Signal Identifier—Allow you to set the path signal identifier. The permissible values range from 0
to 255.
Section Trace Byte—Allows you to set the section trace byte. The permissible values are from 0 to 255.
Note If the device has pre-defined default values for the Path Signal Identifier and Section Trace Byte
parameters, the same values are displayed in this area when the profile is created.
IPS SONET
Protected—Allows you to select the Protected mode. The available options are: enable and disable
SD Threshold <3-9> (in 10e-)—Allows you to select the Signal Degrade threshold value in 10e-,
between 3-9
SF Threshold <3-9> (in 10e-)—Allows you to select the Signal Fail BER threshold value in 10e-,
between 3-9
Create Profile
Create Profile—Choose Create Profile to create a new SRP Side profile.
Alarms Tab
The Alarms tab displays two areas: Reporting & Threshold, and Reporting
Reporting and Threshold
The Alarm Reporting & Threshold area allows you to configure the following information:
B1 BER Threshold Crossing Alarm—Allows you to enable/disable threshold limits for the system to
prompt appropriate B1 BER Threshold alarm messages.
B2 BER Threshold Crossing Alarm—Allows you to enable/disable threshold limits for the system to
prompt appropriate B2 BER Threshold alarm messages.
B3 BER Threshold Crossing Alarm—Allows you to enable/disable threshold limits for the system to
prompt appropriate B3 BER Threshold alarm messages.
Signal Degrade BER—Allows you to enable/disable threshold limits for the system to prompt
appropriate Signal Degrade BER Threshold alarm messages
Signal Fail BER—Allows you to enable/disable threshold limits for the system to prompt appropriate
Signal Fail BER Threshold alarm messages
B1 Threshold <3-9> (in 10e-)—Displays B1 BER threshold value in 10e-, between 3-9
B2 Threshold <3-9> (in 10e-)—Displays B2 BER threshold value in 10e-, between 3-9
B3 Threshold <3-9> (in 10e-)—Displays B3 BER threshold value in 10e-, between 3-9
SD Threshold <3-9> (in 10e-)—Displays Signal Degrade threshold value in 10e-, between 3-9
SF Threshold <3-9> (in 10e-)—Displays Signal Fail BER threshold value in 10e-, between 3-9