Filter
Top Products
8-9
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
Ethernet Interface Configuration
Maximum VCCs—Maximum number of VCCs (PVCs and SVCs) supported at this interface.
Maximum Active VCI Bits—Not applicable to Cisco 12000/10720 Router Manager.
Number of VCs per VP—Set the number of virtual channels per virtual path.
Clock Source—Source of the clock.
NSAP (Network Service Access Point) Address—Specify the NSAP address.
ILMI Configuration
The ILMI Configuration area contains the following fields:
Keepalive Time—Amount of time that should elapse between successive ILMI keepalive messages are
sent on this interface. A value of 0 disables ILMI keepalive messages on this interface.
Auto-Configuration—Enable or disable the ILMI link and interface type determination. The
configuration takes effect only on the next interface restart.
Address Registration—Enable or disable ILMI address registration on this interface. The configuration
takes effect only on the next interface restart.
Configuration—Enable or disable ILMI configuration on this interface. The configuration takes effect
only on the next interface restart. Disabling this object will also disable address registration,
auto-configuration, and keepalive time.
Configuration (2) Tab
The Configuration (2) tab displays three areas: Information Element Transfer, Physical layer and
DS1/E1/DS3/E3.
Information Element Layer
Not applicable to Cisco 12000/10720 Router Manager.
Physical Layer
Not applicable to Cisco 12000/10720 Router Manager.
DS1/E1/DS3/E3
Line Buildout—Not applicable to Cisco 12000/10720 Router Manager.
Framing Mode—The framing format present on the physical interface.
Ethernet Interface Configuration
The Ethernet Interface Configuration window allows you to configure Ethernet fields, such as loopback,
and keepalive period.
The Ethernet Interface Configuration section covers the following areas:
• Viewing the Ethernet Interface Configuration Window
• Configuring an Ethernet Interface
• Ethernet Interface Configuration Window—Detailed Description