Filter
Top Products
5-7
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 5 Managing Modules
Module Fault Management
Module Configuration Window—Detailed Description
The Module Configuration window displays a single Configuration tab.
Configuration Tab
The Configuration tab (see Figure 5-1 on page 5-4) displays three areas: Additional Descriptions
Actions, and Commission Status.
Additional Descriptions
The Descriptions 1 and Descriptions 2 fields (optional) allow you to specify additional description
information for the selected module (if required).
Actions
The Actions area contains two buttons:
Commission—Commissions the selected module.
Decommission—Decommissions the selected module.
Commission Status
The Commission Status area displays the status of the last commission performed on the selected
module. Possible values are Succeeded or Failed.
Module Fault Management
The Module Fault Management window is a read-only window and provides fault information for a
selected module. You do not need to enter any information into any of the fields. This section provides
the following information:
• Viewing the Module Fault Management Window
• Module Fault Management Window—Detailed Description
Viewing the Module Fault Management Window
To view the Module Fault Management window, proceed as follows:
Step 1 Right click on a module and select the Cisco 12000/10720 Manager>Fault>Module Fault
Management option. See Table 5-2 on page 5-2 for information on which objects allow you to launch
the Module Fault Management window. The Module Fault Management window appears, with the Fault
Management tab displayed.