Filter
Top Products
16-9
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 16 MPLS VRF Management
Creating and Configuring the VRF Policy on a Device
To configure and create a VRF policy on a selected device, proceed as follows:
Step 1 Right click on a chassis object and choose Configuration >MPLS> VRF Configuration. See
Table 16-1 on page 16-2 for information on which objects allow you to launch the VRF Configuration
window. The VRF Configuration window appears, with the VRF Configuration tab displayed:
Figure 16-9 VRF Configuration Window
Step 2
Choose a Chassis and VRF from the list box displayed at the left of the window.
Step 3 Configure the fields in the VRF Configuration tab as required. For further information, see the “VRF
Configuration Window—Detailed Description” section on page 16-11.
Step 4 Choose the Save icon on the toolbar to save your changes.
Step 5 Choose Create (located in the Device Actions area) to create (upload) the VRF policy to the chassis. A
status report appears displaying whether the create action succeeded or failed. An error report will
appear if a VRF policy with same name is already present in the device.
Note The Status bar (at the bottom left of the window) displays information about the current state of
the VRF Policy (VRF(1) indicates that the VRF policy is in the applied/uploaded state and
VRF(0) indicates that the VRF policy has been removed from the device).
Once the VRF policy object is created and available in the device, it should be possible to
associate/disassociate that VRF object to/from the interface which inherits the CiscoVRFFunctionality.
See the “Creating and Configuring the VRF Policy on a Device” section on page 16-8 for further details.