7-8
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 7 Interface Profiles
Creating an ATM Interface Profile
NSAP (Network Service Access Point) Address-Specify the NSAP address. Not applicable for Cisco
12000/10720 Router Manager.
Maximum Active VCI Bits—Not applicable for Cisco 12000/10720 Router Manager.
Clock Source—Source of the clock.
ILMI Configuration
The ILMI Configuration area contains the following fields:
Keepalive Time—The amount of time that should elapse between successive ILMI keepalive messages
sent on this interface. A value of 0 disables ILMI keepalive messages on this interface.
Auto-Configuration—You can enable or disable the ILMI link and interface type determination. The
configuration takes effect only on the next interface restart.
Address Registration—You can enable or disable ILMI Address Registration on this interface. The
configuration takes effect only on the next interface restart.
Configuration—Enable or disable ILMI configuration on this interface. The configuration takes effect
only on the next interface restart. Disabling this object will also disable address registration,
auto-configuration, and keepalive time.
Trap—Allows you to enable or disable the ILMI traps.
Actions
Create Profile—Choose Create Profile to create a new profile.
Configuration (2) Tab
The Configuration (2) tab displays three areas: Information Element Transfer, Physical layer and
DS1/E1/DS3/E3.
Information Element Layer
Not applicable to Cisco 12000/10720 Router Manager.
Physical Layer
Not applicable to Cisco 12000/10720 Router Manager.
DS1/E1/DS3/E3
Line Buildout—Not applicable to Cisco 12000/10720 Router Manager.
Framing Mode—The framing format present on the physical interface.
