Filter
Top Products
8-23
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
SRP Interface Configuration
Configuring a SRP Interface
To configure a SRP Interface, proceed as follows:
Step 1 Launch the SRP Interface Configuration window. Refer to Table 8-2 on page 8-2 for information on
which objects allow you to launch the SRP Interface Configuration window.
Step 2 Choose a Chassis, Module, and SRP Interface from the lists displayed at the left side of the window.
Step 3 Edit the parameters displayed in the SRP Interface Configuration window, as required. See “SRP
Interface Configuration Window—Detailed Description” section for further details.
Step 4 Click Save to save your configuration changes.
SRP Interface Configuration Window—Detailed Description
The SRP Interface Configuration window contains two areas: General and IPS
General
Topology Timer—Allows you to configure the time (in seconds) that determines the interval for sending
the topology discovery packets to the ring
Priority Threshold—Allows you to configure the incoming packet priority limit
Tx Traffic Rate – High—Allows you to configure the high rate limit of outgoing traffic, in megabits per
second
Tx Traffic Rate – Low—Allows you to configure the low rate limit of outgoing traffic, in megabits per
second
Note The Priority Threshold, Tx Traffic Rate – High, Tx Traffic Rate – Low parameters are applicable
only to OC-48 SRP Interfaces.
IPS
IPS Lock—Allows you to configure the boolean flag (true or false) to indicate node LockedOut of
protection state.
IPS Timer—Allows you to configure the frequency at which the IPS messages are to be displayed, in
seconds.
IPS Wait To Restore Timer—Allows you to configure the time interval in seconds, for an interface to
remain in the wrap state, after the cause of a wrap is removed.