Filter
Top Products
CHAPTER
7-1
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
7
Interface Profiles
This chapter describes how to create interface profiles using the Cisco 12000/10720 Router Manager
application. Cisco 12000/10720 Router Manager allows you to create and apply profiles to interfaces
(see Figure 7-1).
Figure 7-1 Interface Profiles Workflow
Profiles allow you to apply a set of existing parameters to a number of similar type objects, eliminating
the need to enter the same data numerous times. Once you have created a profile, you can apply that same
profile to a number of interfaces, as applicable. This saves you from having to enter the same
configuration information each time for the same type of objects.
Tip When you choose a profile name, it is recommended to use a naming convention that
describes the profile type. For example, an ATM profile might be called ATM1, a POS
profile might be called POS2, and an HSRP profile could be HSRP1.
Create Interface
Profile(s)
Create interface profile(s) when required.
Profiles allow you to apply a set of existing
parameters to a number of similar type objects.
Apply the Profile
Apply profiles to the appropriate interface
via the Interface Configuration window.
Configure the
Remaining
Parameters
Configure the remaining parameters
and save the interface configuration.
Commission the
Interface
Open the Generic Interface Configuration
window and configure the parameters
as required. Commission the interface.
Profile A
Profile B
56582