Filter
Top Products
12-35
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 12 Managing ATM Connections
ATM PVC Configuration
OAM Information
The OAM Information area is not applicable to Cisco 12000/10720 Router Manager.
Layer 3 Configuration Tab
The Layer 3 Configuration tab (see Figure 12-26) contains the following areas:
• VCL Config
• Interface
• VCL Parameters
• VPI/VCI (including Auto Suggestion feature)
• Subscriber
• OAM Parameters
• Actions
VCL Config
The VCL Config area contains one field:
Encapsulation—The following values can be selected for this field:
• None—No encapsulation is selected.
• ILMI—Used for setting up an ILMI PVC in an SVC environment. In an SVC environment, you must
configure a PVC for communication with the ILMI so that the router can receive SNMP traps and
new network prefixes.
• Qsaal—This signaling PVC can only be set up on ATM main interfaces, not on ATM sub-interfaces.
Interface
The Interface area contains one field:
Sub-Interface Number—The subinterface number under which this PVC is deployed.
VCL Parameters
The VCL Parameters area contains the following fields:
AAL5 Encapsulation—Configure the ATM adaptation layer (AAL) 5 encapsulation type.
Destination IP Address—Enter the IP address of the destination interface to which you want to pass
traffic.
Broadcast—Choose yes if you want to send duplicate broadcast packets for all protocols configured on
a PVC.
VPI/VCI
The VPI/VCI area contains one field:
Auto Suggestion—If you enable auto suggestion, Cisco 12000/10720 Router Manager automatically
suggests VPI or VCI values for you.