Filter
Top Products
8-8
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
ATM Interface Configuration
Step 3 Choose Edit > Apply Profile and then choose the profile you wish to apply from the list displayed (if
you are applying a profile). When a profile is applied, the attributes applied from the profile appear in
blue.
Step 4 Edit the parameters displayed in the Configuration (1) tab, as required. See “ATM Interface
Configuration Window—Detailed Description” section on page 8-8 for further details.
Step 5 Click Save to save your configuration changes.
Step 6 Choose File > Close to close the window.
ATM Interface Configuration Window—Detailed Description
The ATM Interface Configuration window contains two tabs: Configuration (1) and Configuration (2).
Configuration (1) Tab
The Configuration (1) tab (see Figure 8-2) contains two areas: ATM Configuration, and ILMI
Configuration.
ATM Configuration
The ATM Configuration area contains the following fields:
Neighbor IP Address—Not applicable to Cisco 12000/10720 Router Manager.
Neighbor Interface Name—Not applicable to Cisco 12000/10720 Router Manager.
Interface Type—Not applicable to Cisco 12000/10720 Router Manager.
UNI Type—Not applicable to Cisco 12000/10720 Router Manager.
ATM Interface Side—Not applicable to Cisco 12000/10720 Router Manager.
UNI Signalling Version—Version of UNI signalling that is currently being used on the interface. The
appropriate value, either atmfUni3Dot0, atmfUni3Dot1, or atmfUni4Dot0, is used when the interface is
an UNI or IISP interface. The value “not applicable” is used when the interface is a PNNI interface or
when signalling is disabled. Setting this variable to a value of not applicable is not allowed. To modify
this field, the interface admin status has to be down and the interface Ilmi auto configuration disabled.
SVC UPC Intent—Not applicable to Cisco 12000/10720 Router Manager.
Signalling Admin Status—Not applicable to Cisco 12000/10720 Router Manager.
Well-known VC Mode—Not applicable to Cisco 12000/10720 Router Manager.
Loopback—The following options are available:
Line—Packets are transmitted back to the source to test the interface functionality and ensure that
packets transmitted through the interface reach the destination without data loss.
No loopback—Restricts connection status (success or failure) messages from being received.
Diagnostic—Transmit data stream is looped to the transmit direction.
Transmit Queue Limit—Not applicable to Cisco 12000/10720 Router Manager.
Maximum VPCs—Not applicable to Cisco 12000/10720 Router Manager.
Maximum Active VPI Bits—Not applicable to Cisco 12000/10720 Router Manager.