Filter
Top Products
9-11
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 9 Interface Status
DS3/E3 Interface Status
DS3/E3 Status
The DS3/E3 Status area displays the following fields:
Send Code—Type of code that is being sent across the DS-3 interface by the device.
Valid Intervals—Number of previous near end intervals for which data was collected.
Time Elapsed—Number of seconds that have elapsed after the beginning of the near end current error
measurement period started.
Line Coding—Zero code suppression used in this interface.
No Error—No alarms/errors are present in the interface and the traffic signal is colored green.
Loss of Signal—Presence or absence of signal loss in the line.
Loss of Frame—Presence or absence of frame loss in the line.
Loopback State—Indicates whether the received signals are looped or not.
Rx Remote Alarm Indication—Indicates whether remote alarm signal is being received or not.
Rx Alarm Indicate Signal—Indicates whether alarm signal is being received or not.
Rx Test Code—Indicates whether the line is receiving a test pattern or not.
Tx Remote Alarm Indication—Indicates whether remote alarm signal is being transmitted or not.
Tx Alarm Indicate Signal—Indicates whether alarm signal is being transmitted or not.
Far End DS3/E3 Status
The Far End DS3/E3 Status area displays the following fields:
Facility ID Code—Code that identifies a specific far end DS-3 path.
Location ID Code—Far end location identification code that describes the specific location of the
equipment.
Unit Code—Far end code that identifies the equipment location within a bay.
Valid Intervals—Number of previous far end interval for which valid data was collected.
Time Elapsed—Time elapsed after the current far end measurement period started.
Equip Code—Far end equipment identification code that describes the specific piece of equipment.